Mastiff 400 Swing Gate Operator for DOUBLE gates
Regular arm length - 350mm stroke. Able to push a 4m steel gate weighing up to 350kgs with a peak thrust of 3500N.
2 x 24v Actuator Motors with Aluminium casing and Stainless Ram
Standard Mounting Brackets
CB17 Outdoor Control Box with control board, built-in RF receiver/antenna and external cable glands.
3 x TM3 Transmitters
1 x set of 24v backup Batteries.
1 x Outdoor Wireless Keypad.
1 x Gate Metal Stopper for the centre of your driveway with concrete bolts
Fully closed length between centres of bracket pivot pins: 795 mm
Fully open length between centres of bracket pivot pins: 1155mm (Only use 1135mm max for setup allowing for 20mm spare giving a 330mm true stroke length)
This model requires the gate stop (included) to be installed in the centre of your driveway for the gates to make contact with when fully closed. The Mastiff arms also have a keyed release mechanism in them to allow manual movement if ever required (and is used during install).
NOTE: If your posts are more than 200mm wide, you will not be able to hinge the gates in the centre of the posts; they should then be hinged towards the inside property edge of the posts, no more than 100mm in from the post corner.
Warranty; 1 year back to Base. See terms and conditions on this website
Warning: It is the installer’s responsibility to seal the entry points of cables etc from insects and water entering the housing and compromising the control board.