Mastiff-400 Swing Gate Operator for SINGLE gate
Able to push a 4m steel gate with a weight of upto 350kgs with a peak thrust of 3500N. Operating stroke 350mm
1) 1 x 24v Actuator Motor with Aluminium casing and Stainless Ram.
2) Standard Mounting Brackets.
3) CB17 Outdoor Control Box with control board, built-in
RF receiver/antenna and external cable glands.
4) Stand-alone Transformer.
5) 3 x TM3 Transmitter.
6) 1 x set of 24V Back-up Batteries.
7) 1 x Outdoor Wireless Keypad.
9) Instruction Manual
Fully closed length between centres of bracket pivot pins: 795 mm
Fully open length between centres of bracket pivot pins: 1155 mm (Only use 1135mm max for setup allowing for 20mm spare giving a 330mm true stroke length)
NOTE: If your posts are more than 200mm wide, you will not be able to hinge the gates in the centre of the posts, they should then be hinged towards the inside property edge of the posts, no more than 100mm in from the post corner.
Warranty; 1 year back to Base. See terms and conditions on this website
Warning: It is the installer’s responsibility to seal the entry points of cables etc from insects and water entering the housing and compromising the control board.