Mastiff-400 Swing Gate Operator for a SINGLE gate
Operating stroke 540mm
1) 1 x 24v Actuator Motor with Aluminium casing and Stainless Ram.
2) Standard Mounting Brackets.
3) CB17 Outdoor Control Box with control board, built-in
RF receiver/antenna and external cable glands.
4) Stand-alone Transformer.
5) 3 x TM3 Transmitter.
6) 1 x set of 24V Back-up Batteries.
7) 1 x Outdoor Wireless Keypad.
9) Instruction Manual
Fully closed length between centres of bracket pivot pins: 795 mm
Fully open length between centres of bracket pivot pins: 1540 mm (Only use 1520mm max for setup allowing for 20mm spare giving a 520mm true stroke length)
NOTE: If your posts are more than 200mm wide, you will not be able to hinge the gates in the centre of the posts, they should then be hinged towards the inside property edge of the posts, no more than 100mm in from the post corner.
Warranty; 1 year back to Base. See terms and conditions on this website
Warning: It is the installer’s responsibility to seal the entry points of cables etc from insects and water entering the housing and compromising the control board.